Table of Contents
Advertisement
Interactions (cont'd)
8.
OUTGOING TRUNK QUEUING [O-2]: A user cannot be placed in a Ringback queue while holding
another call on HOLD.
9.
Attendant calls cannot be held.
10.
ATTENDANT CAMP-ON [A-1]: CALL HOLD - D
ON has already been set.
Programming
STEP 1:
ASYD - System Data 1, Index 139. No Answer Timer for CALL HOLD. (When Station A places
Station B on HOLD, and hangs up, Station A will ring after a preset period of time has elapsed. If
Station A does not answer, then Station B goes from ringback tone to reorder tone.)
System Data 2, Index 1, Bits 0 & 1. CONSULTATION HOLD [C-17] allowed or denied. 00: Denied;
Originating and Terminating Calls allowed, Tandem Calls Denied; 11: All calls allowed.
STEP 2:
ANPD - Reserve a number level for feature access and cancel. Assign for Normal (N), Hooking (H),
and Busy (B). Assign NND in accordance with a predetermined numbering plan.
STEP 3:
ASPA - Assign an access code for CALL HOLD, SID = 1 for Connection Status Index (CI) Hooking
(H).
STEP 4:
ASFC - Assign a Service Feature Class that allows SFI = 10 to stations that are allowed CALL
HOLD.
STEP 5:
AKYD - Assign Call Hold to a programmable Line Feature key. Assign Type:Function:CALL HOLD
[10]. (The operation of TRANSFER key and access code is also available). Type:Function:FLASH
BUTTON [21].
STEP 6:
ADSL - Assign SN=5 (Consultation Hold) and FKY=10 (Call Hold; HLD)
This command is required only for assigning the function to each soft key.
To operate a D
and FKY=21 (Flash Button; FLASH).
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1:
ANPDL - Reserve a number level for feature access and cancel. Assign for Normal (N), Hooking (H),
and Busy (B). Assign NND in accordance with a predetermined numbering plan.
STEP 2:
ASPAL - Assign an access code for CALL HOLD, SID = 1 for Connection Status Index (CI) Hooking
(H).
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
System timers may be set on a network basis in ASYDN.
Note 2:
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Call Hold - D
term
via the FLASH BUTTON [F-3D], assign SN=4 (Communication is in Progress)
Note 1
term
term
cannot be activated when ATTENDANT CAMP-
C-6D
Page 143
Advertisement
Table of Contents
