Tool Selection Is Incorrect; No Spec: Mrc Cycle; Program Error (Mrc); Block Over (Mrc) - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P199

Tool selection is incorrect

Details
A turning tool shape compensation was commanded while a tool other than turning tool has been selected.
Remedy
Select "Lathing" for tool type in tool management data before giving the turning tool shape compensation
command.
P200

No spec: MRC cycle

Details
The compound type fixed cycle for turning machining I (G70 to G73) was commanded though it is out of spec-
ifications.
Remedy
Check the specifications.
P201

Program error (MRC)

Details
The subprogram, called with a compound type fixed cycle for turning machining I command, has at least
one of the following commands: reference position return command (G27, G28, G29, G30); thread cutting
(G33, G34); fixed cycle skip-function (G31, G31.n).
An arc command was found in the first movement block of the finished shape program in compound type
fixed cycle for turning machining I.
Remedy
Delete G27, G28, G29, G30, G31, G33, G34, and fixed cycle G codes from the subprogram called with
the compound type fixed cycle for turning machining I commands (G70 to G73).
Delete G02 and G03 from the first movement block of the finished shape program in compound type fixed
cycle for turning machining I.
P202

Block over (MRC)

Details
The number of blocks in the shape program of the compound type fixed cycle for turning machining I is over
50 or 200 (the maximum number differs according to the model).
Remedy
Set a 50/200 or less value for the number of blocks in the shape program called by the compound type
fixed cycle for turning machining I commands (G70 to G73). (The maximum number differs according to the
model).
P203 D cmnd figure error (MRC)
Details
A proper shape will not obtained by executing the shape program for the compound type fixed cycle for turning
machining I (G70 to G73).
Remedy
Correct the shape program for the compound type fixed cycle for turning machining I (G70 to G73).
P204 E cmnd fixed cycle error
Details
A command value of the compound type fixed cycle for turning machining (G70 to G76) is illegal.
Remedy
Correct the command value of the compound type fixed cycle for turning machining (G70 to G76).
P210 No spec: Pattern cycle
Details
A compound type fixed cycle for turning machining II (G74 to G76) command was commanded though it is out
of specifications.
Remedy
Check the specifications.
IB-1501279-H 136