Mitsubishi Electric M800 Series Manual page 2

This manual is a guide for using the MITSUBISHI CNC.
Supported models are as follows:
Supported model
M800W Series
M800S Series
M80W Series
M80 Series
E80 Series
C80 Series
Be sure to keep this manual always at hand.
Notes on Reading This Manual
(1) This manual explains general parameters as viewed from the NC.
For information about each machine tool, refer to manuals issued from the machine manufacturer.
If the descriptions relating to "restrictions" and "allowable conditions" conflict between this manual and the machine manu-
facturer's instruction manual, the later has priority over the former.
(2) This manual is intended to contain as much descriptions as possible even about special operations.
The operations to which no reference is made in this manual should be considered impossible.
CAUTION
For items described as "Restrictions" or "Usable State" in this manual, the instruction manual issued by the machine tool
builder takes precedence over this manual.
Items not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all the applicable functions are included. Some of them, however, may not
be available for your NC system. Refer to the specifications issued by the machine tool builder before use.
Refer to the Instruction Manual issued by each machine tool builder for details on each machine tool.
Some screens and functions may differ depending on the NC system (or its version), and some functions may not be pos-
sible. Please confirm the specifications before use.
Do not connect NC system to the Internet-connected network.
To maintain the safety of the NC system against unauthorized access from external devices via the network, take appro-
priate measures.
In this manual, the following abbreviations might be used.
L system: Lathe system
M system: Machining center system
MTB: Machine tool builder
Also refer to the manuals on "Manual List" as necessary.
Introduction
Abbreviations in this manual
M800 Series, M800, M8
M80 Series, M80, M8
E80, M800/M80 Series, M8
C80