Mitsubishi Electric M800 Series Manual page 392

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1019 dia
Select the command method of program travel amount.
When the travel amount is commanded with the diameter dimensions, the travel distance will be 5mm when
the command is 10mm of travel distance.
The travel amount per pulse will also be halved during manual pulse feed.
If diameter is selected, tool length, the wear compensation amount, and the workpiece coordinate offset will
be displayed in diameter value. Other parameters concerning length will always be displayed in radius value.
0: Command with travel amount
1: Command with diameter dimension
(PR) #1020 sp_ax
Select "1" when using the spindle for contour control of NC axis (C-axis).
Select "2" to implement the spindle-mode rotary axis control.
---Setting range---
0: Servo axis is used for contour control.
1: Spindle is used for contour control.
2: Spindle-mode rotary axis control.
(PR) #1021 mcp_no
Using a 4-digit number, set the drive unit interface channel No. and which axis in that channel is to be used
when connecting a servo drive unit.
(PR) #1022 axname2
Set the name of the axis displayed on the screen with two characters. (X1, Z2, etc.)
Always use an alphabetic character (A to Z) for the first character.
---Setting range---
A to Z and 1 to 9 (Two digits)
(Setting will be cleared when "0" is set)
(PR) #1023 crsadr
Set the axis name for issuing a command to this axis during mixed control (cross axis control).
---Setting range---
A to Z
(Setting will be cleared when "0" is set)
(PR) #1024 crsinc
Set the axis name for issuing an incremental command to this axis during mixed control (cross axis control).
---Setting range---
A to Z
(Setting will be cleared when "0" is set)
(PR) #1061 intabs
Select whether to update the absolute position data during automatic handle interrupt.
This parameter is enabled only when "#1145 l_abs" is set to "1".
0: Do not update (coordinate system shifted the amount of the interruption)
1: Update (same coordinates as when interrupt did not occur will be applied)
Axis No.
Not used (Set to "0")
Drive unit interface channel No.
375
Diameter specification axis
Spindle interpolation
Drive unit I/F channel No. (servo)
2nd axis name
Command address during mixed control (cross axis
control)
Incremental command address during mixed control
(cross axis control)
Manual ABS updating
IB-1501279-H