Start Code; Ctrl. Code Out; Ctrl. Interval; Wait Time - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#9613 Link PARAM. 5
[M8]
Not used. Set to "0".
#9614

START CODE

[M8]
Select the code used to command the first transfer of file data.
This parameter is used for a specific user. Normally set "0".
0: DC1 (11H)
1: BEL (07H)
#9615

CTRL. CODE OUT

[M8]
bit 0: NAK output
Select whether to send the NAK code to the host if a communication error occurs in computer link B.
0: Not output the NAK code
1: Output the NAK code.
bit 1: SYN output
Select whether to send the SYN code to the host if NC resetting or an emergency stop occurs in computer
link B.
0: Not output the SYN code.
1: Output the SYN code.
bit 3: DC3 output
Select whether to send the DC3 code to the host when the communication ends in computer link B.
0: Not output the DC3 code.
1: Output the DC3 code.
#9616

CTRL. INTERVAL

[M8]
Not used. Set to "0".
#9617

WAIT TIME

[M8]
Not used. Set to "0".
#9618 PACKET LENGTH
[M8]
Not used. Set to "0".
#9619 BUFFER SIZE
[M8]
Not used. Set to "0".
#9620 START SIZE
[M8]
Not used. Set to "0".
#9621 DC1 OUT SIZE
[M8]
Not used. Set to "0".
#9622 POLLING TIMER
[M8]
Not used. Set to "0".
IB-1501279-H 272