Mitsubishi Electric M800 Series Manual page 474

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #11005 PC IP address
[M8]
Set the IP address for the display unit or PC in which machining programs are stored.
Set the IP address for the display unit of which power is turned OFF with automatic power OFF.
When the 3D machine interference check function is enabled, set the IP address of the display unit that is
used for the 3D machine interference check (for M800W only).
(Note) When "0.0.0.0" is input, "192.168.100.2" is automatically set.
* This parameter is dedicated to M800W/M80W with Windows-based display.
PC Subnet
Set the subnet mask for the display unit or PC in which machining programs are stored.
PC Gateway
Set the gateway for the display unit or PC in which machining programs are stored.
---Setting range---
0.0.0.0 to 255.255.255.255
[C80]
Not used.
#11006 PC Port number
[M8]
Set the port No. for the display unit or PC in which machining programs are stored.
(Note 1) When "0" is input, "55555" is automatically set.
(Note 2) When changing the parameter, set the same value in "PD_Control_Port" in the PC side environment
setting file.
---Setting range---
0 to 65535
[C80]
Not used.
(PR) #11007 PC Timeout
[M8]
Set the NC side communication timeout time.
Set the timeout time for the display unit to be shut down upon automatic power OFF request.
(Note 1) When "0" is input, "120" is automatically set.
(Note 2) When the value greater than "300" is set, a setting error occurs.
(Note 3) When changing the parameter, set the same value in "PD_Time_out" in the PC side environment
setting file.
---Setting range---
0 to 300 (s)
[C80]
Not used.
(PR) #11009 M2 label O
Select the program number label when using the M2 format.
0: Label L
1: Label O
IP address setting
Port No. setting
Communication timeout time setting
M2 label O
457 IB-1501279-H