M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#42009
P1-spcanag
Cancel angle for machining condition selection I
Set the cancel angle for the machining condition selection I function.This is equivalent to the parameter
#8026 CANCEL ANG.
---Setting range---
0 to 180 (deg)
#42010
P1-distth1
Chord error 1 for machining condition selection I
Set the chord error 1 for the machining condition selection I function. This is equivalent to the parameter
#8027 Toler-1.
---Setting range---
0.000 to 100.000 (mm)
#42011
P1-distth2
Chord error 2 for machining condition selection I
Set the chord error 2 for the machining condition selection I function. This is equivalent to the parameter
#8028 Toler-2.
---Setting range---
0.000 to 100.000 (mm)
#42012
P1-minute
Fine segment length for machining condition selection I
Set the fine segment length for the machining condition selection I function. This is equivalent to the param-
eter #8030 MINUTE LENGS.
---Setting range---
-1 to 127 (mm)
#42013
P1-fairing
Fairing ON for machining condition selection I
Set whether to enable the fairing function for the machining condition selection I function. This is equivalent
to the parameter #8033 Fairing ON.
---Setting range---
0/1
#42014
P1-minleng
Fairing L for machining condition selection I
Set the fairing length for the machining condition selection I function. This is equivalent to the parameter
#8029 FairingL.
---Setting range---
0 to 100.000 (mm)
#42015
P1-cordeclen
Corner judgment length for machining condition selection I
Set the corner judgment length for the machining condition selection I function. This is equivalent to the pa-
rameter #8037 CorJudgeL.
---Setting range---
0 to 99999.999 (mm)
#42016
P1-sss_prcm
SSS/EasySSS control ON for machining condition selection I
Set whether to enable the SSS/EasySSS control for the machining condition selection I function. This is
equivalent to the parameter #8090 SSS ON.
---Setting range---
0/1
Cancel angle for machining condition selection I
Chord error 1 for machining condition selection I
Chord error 2 for machining condition selection I
Fine segment length for machining condition selection I
Fairing ON for machining condition selection I
Fairing L for machining condition selection I
Corner judgment length for machining condition selec-
tion I
SSS/EasySSS control ON for machining condition se-
lection I
323
IB-1501279-H