Mitsubishi Electric M800 Series Manual page 423

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1247 set19
bit0: Movement by tool length compensation command (for M system only)
Select whether or not to move the axis by the compensation amount when tool length compensation/cancel
is independently commanded.
0: Move
1: Not move
bit1: Thread cutting operation when manual speed command enabled
Select the thread cutting operation in manual speed command.
0: The axis travels at the handle feed rate, jog feed rate, or manual rapid traverse rate
1: The axis travels following the program command
bit2: Inclined surface machining mode hold
Select whether to hold or cancel the inclined surface machining mode at an emergency stop or power OFF.
0: Cancel the inclined surface machining mode.
1: Hold the inclined surface machining mode.
#1248 set20
Not used. Set to "0".
#1249 set21
bit5: Warning on 24Hr continuous ON display
Select whether to show or hide the alarm (V53 0001).
0: Not display
1: Display
#1250 set22
bit0: Enable cycle operation after turning OFF manual arbitrary reverse run mode
[M8]
Select whether to enable automatic cycle operation after turning OFF the manual arbitrary reverse run mode.
0: Disable
1: Enable
[C80]
Not used.
bit3 : Switch acceleration for rapid traverse
[M8]
Select how to determine the acceleration for rapid traverse (G0) in high-accuracy control.
This parameter is enabled during tool center point control, workpiece installation error compensation or in-
clined surface machining command.
0: The acceleration is determined by "#1206 G1bF (Maximum speed)" and "#1207 G1btL (Time constant)"
and is common to all axes.
1: The acceleration is determined by "#2001 rapid (Rapid traverse rate)" and "#2004 G0tL (G0 time con-
stant (linear))" and is individual for each axis.
[C80]
Not used.
IB-1501279-H 406