Mitsubishi Electric M800 Series Manual page 221

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#1188 spd_F4
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F4 is issued (mm/min)
When "#1246 set08/bit6" is set to "1" and F 1-digit feed is commanded, the feedrate can be increased/de-
creased by operating the manual handle.
---Setting range---
0 to 1000000 (mm/min)
#1189 spd_F5
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F5 is issued (mm/min)
When "#1246 set08/bit6" is set to "1" and F 1-digit feed is commanded, the feedrate can be increased/de-
creased by operating the manual handle.
---Setting range---
0 to 1000000 (mm/min)
#1506 F1_FM
Set the maximum value up to which the F 1-digit feedrate can be changed.
---Setting range---
0 to 1000000 (mm/min)
#1507 F1_K
Set the constant that determines the speed change rate per manual handle graduation in F 1-digit feedrate
change mode.
---Setting range---
0 to 32767
#8001 WRK COUNT M
Set the M code for counting the number of the workpiece repeated machining.
The number of the M-codes set by this parameter is counted.
The No. will not be counted when set to "0".
---Setting range---
0 to 999
#8002 WRK COUNT
Set the initial value of the number of workpiece machining. The number of current workpiece machining is
displayed.
---Setting range---
0 to 999999
#8003 WRK COUNT LIMIT
Set the maximum number of workpiece machining.
A signal will be output to PLC when the number of machining times is counted to this limit.
---Setting range---
0 to 999999
#8004 SPEED
Set the feedrate during automatic tool length measurement.
---Setting range---
1 to 1000000 (mm/min)
IB-1501279-H
F1 digit feedrate F4
F1 digit feedrate F5
Upper limit of F1-digit feedrate
F 1-digit feedrate change constant
204