Plc Axis Indexing Parameters - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters

16.25 PLC Axis Indexing Parameters

(PR) #12800 chgauxno
Set the axis No. to be controlled as auxiliary axis using auxiliary axis interface.
When "0" is set, the axis will not operate as auxiliary axis.
---Setting range---
[M8]
0 to 8: (M800W/M800S Series)
0 to 4: (M80/M80W Series)
0 to 1: (E80)
[C80]
0 to 8
(PR) #12801 aux_station
Set the number of stations.
For linear axis, this value is expressed by: number of divisions = number of stations -1.
Setting "0" or "1" sets the number of stations to 2.
---Setting range---
0 to 360
(PR) #12802 aux_Cont1
The bits that are not explained here must be set to "0".
Bit3:
0: Automatic reach signal isn't interlocked with the start signal.
1: Automatic reach signal is interlocked with the start signal.
Bit4:
0: Automatic reach signal is turned ON again.
1: Automatic reach signal isn't turned ON again.
Bit5:
0: Station No. Output within fixed position.
1: Station No. Constantly output.
bit9:
0: Rotation direction determined by operation control signal (DIR)
1: Rotation direction in the shortcut direction
bitE:
0: Rotation direction in operation control signal (DIR) or in the shortcut direction
1: Rotation direction in the arbitrary position command sign direction
bitF:
0: Stopper direction is in the positioning direction.
1: Stopper direction is in the sign direction of the stopper amount.
(PR) #12803 aux_Cont2
The bits that are not explained here must be set to "0".
bit4:
0: Uniform assignment
1: Arbitrary coordinate assignment
(PR) #12804 aux_tleng
Set the movement stroke length for linear axes.
(Note 1) Setting "0.000" causes an MCP alarm at the power ON.
(Note 2) This parameter is meaningless at the non-uniform index or random position command.
---Setting range---
0.000 to 99999.999 (mm)
IB-1501279-H
Auxiliary axis number
Number of indexing stations
Control parameter 1
Control parameter 2
Linear axis stroke length
674