Mitsubishi Electric M800 Series Manual page 441

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1280 ext16
bit0: I/F per axis during mixed control (cross axis control)
Select how to handle the following PLC interface for axes interchanged with the mixed control (cross axis
control).
- Mirror image
- Manual/automatic interlock
- Manual/automatic machine lock
0: Follows axis configuration before the mixed control (cross axis control).
1: Follows axis configuration after the mixed control (cross axis control).
(Example)
The device No. of automatic interlock (+) for X1 will be as follows when the mixed control (cross axis control)
is executed with the 1st axis (X1) in the 1st part system and 1st axis (X2) in the 2nd part system.
When "0" is set: YA60 (interface for 1st axis in 1st part system)
When "1" is set: YA68 (interface for 1st axis in 2nd part system)
(Note) If the number of axes in the part system changes with the mixed control (cross axis control), the inter-
face of the target axis may change when this parameter is set to "1".
bit1: Mixed control (cross axis control) cancel with reset
Select whether to cancel the mixed control (cross axis control) when reset is applied.
0: Cancel.
1: Not cancel.
bit2: Interchange coordinate position display
Select whether to display interchanged (or moved) coordinate positions in the mixed control (cross axis con-
trol).
This setting will be applied when the axes are moved, as well as when the axes are interchanged.
0: Display interchanged (or moved) coordinate positions.
1: Display coordinate positions without being interchanged (nor moved).
(Example)
When 1st part system's C axis is moved to 2nd part system with a 1st part system (X, Z, C, Y) and 2nd part
system (X, Z) configuration:
1st part system: X, Z and Y coordinate positions are displayed.
2nd part system: X, Z and C coordinate positions are displayed.
bit3: Reset operation for synchronization/super-imposition control
Select whether to cancel synchronization/superimposition control when reset is applied.
0: Cancel.
1: Not cancel.
bit4: Mixed control (cross axis control) command method
Select how to command mixed control (cross axis control).
0: Use PLC interface signal for mixed control
1: Use G command for mixed control
bit5: Command method of control axis synchronization across part systems
Select how to command the control axis synchronization across part systems.
0: Use PLC I/F.
1: Use G command.
IB-1501279-H 424