M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M03
Interfere:2 rot axes object er
Details
The solid object set in the interfering object definition is unavailable as an interfering object defined with two
rotary axes.
Remedy
Correct the setting of the solid in the interfering object definition.
M03
Interfere:1 rot axis object er
Details
The solid object set in the interfering object definition is unavailable as an interfering object defined with one
rotary axis.
Remedy
Correct the setting of the solid in the interfering object definition.
M03
Interf. selection: offset over
Details
In the interfering object selection, the interfering object model coordinate system offset 1 has exceeded the set-
ting.
Remedy
Correct the setting of the interfering object model coordinate system offset 1 in the interfering object se-
lection.
M03
Interf:rot objects comb. error
Details
The following selection was made for the rotary interfering objects:
You selected a one-rotary-axis object and two-rotary-axis object at a time.
You selected two or more two-rotary-axis objects.
Remedy
Correct the setting of the n-th interfering object selection.
M50
Workpiece offset unreflected
Details
Any of the following offsets of the selected modal has not been reflected in the workpiece position counter:
workpiece offset, extended workpiece offset, external workpiece offset or workpiece shift.
Remedy
The warning is cancelled by any of the following operations.
Cycle start
Reset
Emergency stop
M90
Parameter set mode
Details
The setup parameter lock is released.
Cycle start is disabled when setup parameters can be set.
Remedy
Refer to the manual issued by the machine tool builder.
M97
Maintenance part activated
Details
Activated maintenance part has not completed the product procedures.
Remedy
Contact our service center.
IB-1501279-H
2005
2006
3001
3002
36
Interference object defi-
nition number
Interference object defi-
nition number
Interference object defi-
nition number
Interference object defi-
nition number
5000