Rot Center Err Comp Excessive; Unable To Start Measuring Err; Invalid Op Mode In Err Measure; Machining Surface Operation Disabled - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

Rot center err comp excessive

Details
Compensation amount calculation was excessive, so the amount was clamped by +/- 1mm.
Remedy
Review the position deviation and angular deviation values.
M01

Unable to start measuring err

Details
You executed cycle start while measurement of rotation center error or workpiece installation error is invalid.
Remedy
Execute cycle start for one part system that is ready for measurement.
Activate memory mode before executing cycle start.
M01

Invalid op mode in err measure

Details
You switched the operation to any mode other than memory during measurement of rotation center error or
workpiece installation error.
Remedy
Switch the operation to memory mode.
Manual interruption, automatic operation handle interruption, MDI interruption, etc. are invalid during error mea-
surement.
Execute cycle start after completion or cancel of the measurement.
M01

Machining surface operation disabled

Details
Machining surface operation (selection, indexing or cancel) was attempted while the operation is disabled.
Remedy
 Cancel the other modes so that the inclined surface machining command (G68.2), tool axis direction con-
trol (G53.1) and the inclined surface machining cancel command (G69) can be issued.
Wait until the axes stop completely (until the smoothing for all axes reaches zero).
Perform operation search for machining programs.
M01 Axs travel n/a in manual index
Details
Moving a rotary axis was attempted during manual machining surface indexing, when a manual operation
mode other than handle mode was selected.
Remedy
Change the operation mode to a handle mode before carrying out the manual surface indexing.
M01 Tool length compensation amt 0
Details
The tool length compensation amount for performing the R-Navi indexing type 2 is 0.
Remedy
Set the tool length compensation amount for performing the indexing type 2 to a value other than 0.
M01 Feat coord ill w/ multi-handle
Details
Manual feed feature coordinate system was selected while two or more handles were ON.
Remedy
Manual feed on a feature coordinate system is disabled while two or more handles are enabled (*).
Press [Manual coord] and select the machine coordinate system.
Reduce the number of enabled handles (*) to one.
(*) An enabled handle means the handle for which "Nth handle valid" signal (HSnS) is ON.
21
0241
0245
0246
0250
0251
0252
0253
IB-1501279-H