Mitsubishi Electric M800 Series Manual page 385

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #12041 MblkstpMin5
Set the minimum value of the M code to which pre-read will not be applied.
---Setting range---
0 to 99999999
(PR) #12042 MblkstpMax5
Set the maximum value of the M code to which pre-read will not be applied.
---Setting range---
0 to 99999999
(PR) #12043 MblkstpMin6
Set the minimum value of the M code to which pre-read will not be applied.
---Setting range---
0 to 99999999
(PR) #12044 MblkstpMax6
Set the maximum value of the M code to which pre-read will not be applied.
---Setting range---
0 to 99999999
#12049 SBS_no
Specify the ID number (address B value) to be used when activating this part system as a sub part system
during G122 command.
Set to 0 when this part system is not used as a sub part system.
---Setting range---
0 to 7
#12050 SBS_pro
Specify the No. of program to be called when activating this part system as a sub part system during G122
command. This parameter setting is used when a program designation (address A value/<file name>) is omit-
ted.
---Setting range---
0 to 99999999
#12051 Jerk_filtG1
Specify the time constant of filter that is used for smoothing the change of jerk when pre-interpolation accel-
eration/deceleration is performed in cutting feed.
This filter causes no path error, as the filter is applied to the total speed calculated before interpolation.
If you specify the jerk filter time constant, the time constants of each filter will be as follows:
* S-shape filter time constant
"#1568 SfiltG1" - "Jerk_filtG1"
* Jerk filter time constant
"Jerk_filtG1"
---Setting range---
0 to 50 (ms)
IB-1501279-H
Minimum value of the pre-read prohibited M code range
setting 5
Maximum value of the pre-read prohibited M code range
setting 5
Minimum value of the pre-read prohibited M code range
setting 6
Maximum value of the pre-read prohibited M code range
setting 6
Sub part system I identification No.
Sub part system I standard program No.
G01 jerk filter
368