Aux Ax Torque Limit Value Zero; Ill. Op During T Tip Control; Illegal Op In Spline Interpol2; Illegal Op In Tilted Face Cut - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

Aux ax torque limit value zero

Details
Torque limit value of the parameter group to use is "0".
Remedy
Check the torque limit value of the parameter group to use (#12814 aux_TL1, #12824 aux_TL2, #12834
aux_TL3, or #12844 aux_TL4).
M01

Ill. op during T tip control

Details
Illegal operation was attempted during tool tip center control.
Remedy
Change the operation mode to the previous one and restart.
M01

Illegal op in spline interpol2

Details
Any of the following operations was performed during spline interpolation 2.
Change to manual mode
Change to MDI mode
PLC interruption
Remedy
Return to the original operation mode, and then remove the error cause.
M01

Illegal OP in tilted face cut

Details
Any of the following illegal operations was attempted during inclined surface machining mode.
Manual interrupt
Handle interrupt in automatic operation
MDI interrupt
PLC interrupt
Arbitrary reverse run
Remedy
Switch the operation mode back to the previous to remove the cause of this failure.
During inclined surface machining mode, it's impossible to perform manual interrupt, handle interrupt in
automatic operation, MDI interrupt, PLC interrupt, etc.
M01 5-axis control config. error
Details
The operation you input cannot be executed under the axis configuration of the part system.
3D manual feed was attempted.
The rotation center error compensation has been turned ON.
The rotary axis is set to the spindle mode of the spindle position control.
Remedy
Check the rotary axis configuration parameters.
Correct the axis configuration of the part system.
Press the reset button to cancel this alarm.
IB-1501279-H 18
0167
0170
0180
0185
0186