F 1-Digit Feed Rate Zero; Spindle Stop; Handle Feed Ax No. Illegal; Spindle Rotation Speed Over - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

F 1-digit feed rate zero

Details
The F1-digit feedrate has been set to "0" when the F1-digit feed command was executed.
Remedy
Set the F1-digit feedrate (the parameter "#1185 spd_F1" (F1 digit feedrate F1) to "#1189 spd_F5" (F1 digit
feedrate F5)).
M01

Spindle stop

Details
The spindle stopped during the synchronous feed/thread cutting command.
Remedy
Rotate the spindle.
If the workpiece is not being cut, start dry run.
Check for any broken wire in the spindle encoder cable.
Check the connections for the spindle encoder connectors.
Check the spindle encoder pulse.
Correct the program. (commands and addresses)
M01

Handle feed ax No. illegal

Details
The axis, designated at handle feed, is out of specifications.
No axis has been selected for handle feed.
Multiple axes in a part system are allocated to a handle.
Remedy
Check for any broken wires in the handle feed axis selection signal line.
Correct the sequence program.
Check the number of axes in the specifications.
Check the axis allocation to the handle.
M01

Spindle rotation speed over

Details
Spindle rotation speed exceeded the axis clamp speed during the thread cutting command.
Remedy
Lower the commanded rotation speed.
M01 Fixed pnt mode feed ax illegal
Details
The axis, designated in the manual arbitrary feed, is out of specifications.
The feedrate in manual arbitrary feed mode is illegal.
Remedy
Check for any broken wires in the axis selection signal line or the feedrate line for the manual arbitrary feed
mode.
Check the specifications for the manual arbitrary feed mode.
M01 Block start interlock
Details
An interlock signal has been input to lock the block start.
Remedy
Correct the sequence program.
M01 Cutting block start interlock
Details
An interlock signal has been input to lock the cutting block start.
Remedy
Correct the sequence program.
11
0104
0105
0106
0107
0108
0109
0110
IB-1501279-H