M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#2123
G0vback=
Set the compensation amount for the range of each position during rapid traverse.
(+: B1, =: B2, -: B3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
#2124
G0vback-
Set the compensation amount for the range of each position during rapid traverse.
(+: B1, =: B2, -: B3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
#2125
G1vback+
Set the compensation amount for the range of each position during cutting feed.
(+: A1, =: A2, -: A3 on the compensation amount table)
---Setting range---
-99999999 to 99999999(Interpolation unit)
#2126
G1vback=
Set the compensation amount for the range of each position during cutting feed.
(+: A1, =: A2, -: A3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
#2127
G1vback-
Set the compensation amount for the range of each position during cutting feed.
(+: A1, =: A2, -: A3 on the compensation amount table)
---Setting range---
-99999999 to 99999999 (Interpolation unit)
#2128
G1vback feed1
Set the speed range during cutting feed.
(The speed less than 1 is the low speed, and the speed exceeding 2 is the high speed.)
Note that the speed range is identified in the order of low, high and medium speed. Consider whether the set
value should be larger or smaller than other values.
---Setting range---
0 to 480000 (mm/min)
#2129
G1vback feed2
Set the range of the speed during cutting feed.
(The speed less than 1 is the low speed, and the speed exceeding 2 is the high speed.)
Note that the speed range is identified in the order of low, high and medium speed. Consider whether the set
value should be larger or smaller than other values.
---Setting range---
0 to 480000 (mm/min)
#2130
G1vback dist1
Set the range of the distance during cutting feed.
(The distance less than 1 is the small distance, and the distance exceeding 2 is the large distance.)
Note that the distance range is identified in the order of small, large and medium. Consider whether the set
value should be larger or smaller than other values.
---Setting range---
0 to 999999.999999 (mm)
Variable G0 backlash =
Variable G0 backlash -
Variable G1 backlash +
Variable G1 backlash =
Variable G1 backlash -
G1 variable backlash compensation amount change-
over speed 1
G1 variable backlash compensation amount change-
over speed 2
G1 variable backlash compensation amount change-
over distance 1
481
IB-1501279-H