2Nd Add T-Ofs On; 2Nd Add T-Ofs Set; C_Mintyp - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#12088 Drn_F
Specify a dry run speed for each part system.
When 0 is set, the manual feed rate selected by Manual feedrate method selection (JVS) signal is applied.
---Setting range---
0 to 1000000(mm/min)
#12089 M2adr
Select the address type of the 2nd miscellaneous function.
0: One-letter command for the 2nd miscellaneous function
1: Two-letter command for the 2nd miscellaneous function
(PR) #12090 SnG43.1
Specify which spindle to be selected when G43.1 is commanded.
<Spindle No. type>
Specify by the spindle No. 1 to 8.
The 1st spindle is selected if you specify a nonexistent spindle No.
<Spindle name type>
Specify by the spindle name 1 to 9.
The 1st spindle is selected if you specify a nonexistent spindle name.
(Note) If names (1 to 9) have been set in the spindle name parameter "#3077 Sname" for all spindles, <Spin-
dle name type> is used.
---Setting range---
0 to 9
(PR) #12103

2nd add T-ofs ON

Select whether to enable tool offset on the 2nd additional axis.
0: Disable
1: Enable
(PR) #12104

2nd add T-ofs set

Select on which axis to perform the 2nd additional axis tool offset.
Specify the axis address set in "#1013 axname".
---Setting range---
X,Y,Z,U,V,W,A,B,C
#12105

C_minTyp

Specify the operation when the turning angle is set the minimum turning angle (#1521 C_min) or less and
the turning operation is not inserted, in the seams of the arc blocks during normal line control.
0: Interpolate before reaching arc end point.
1: Do not interpolate.
#12110 Ret3
[M8]
Specify the axis to be moved later after tool return.
This is referred to with the movement path (transit point #2 to transit point #1).
One bit represents one axis. Up to eight axes can be specified.
---Setting range---
00000000 to 11111111 (Binary)
Dry run speed
2nd miscellaneous function address type
Spindle designation for G43.1
2nd additional axis tool offset ON (for L system only)
2nd additional axis tool offset setting (for L system on-
ly)
Operation selection of minimum turning angle or less
Return type 3
371 IB-1501279-H