M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01
GB SP sync:Phase mem sgnl ilgl
Details
The guide bushing spindle synchronization phase memory signal was turned ON while the master spindle
or guide bushing spindle was rotating.
The guide bushing spindle synchronization phase memory signal was turned ON while the guide bushing
spindle synchronization signal was OFF.
Remedy
Check the ladder program.
M01
GB SP sync:Phase set sgnl ilgl
Details
The guide bushing spindle synchronization phase alignment signal was turned ON while the master spin-
dle or guide bushing spindle was stopped.
Remedy
Check the ladder program.
M01
GB SP sync:Z phase not pass
Details
When the guide bushing spindle synchronization phase memory signal was ON, the master spindle or
guide bushing spindle's Z-phase was not passed.
Remedy
Check the ladder program.
M01
Cmnd impsbl in spindle rtry ax
Details
Toward the synchronous tapping spindle, the switch to servo-mode is commanded to the spindle-mode rotary
axis.
The spindle-mode rotary axis in servo-mode is commanded as the synchronous tapping spindle.
Remedy
Switch to the spindle-mode rotary axis.
M01
Other cmnd disabled in orient.
Details
Spindle superimposition control command has been given to an orientation mode spindle with the said
spindle treated as either the basic or superimposed spindle.
Orientation command has been given to the basic or superimposed spindle that is under spindle superim-
position control.
Remedy
Cancel the orientation mode.
Use G113 or the "Spindle sync cancel" signal to cancel spindle superimposition.
M01
SP-C ax ctrl runs independntly
Details
C axis mode command has been issued for polygon machining spindle.
C axis mode command has been issued for synchronized tapping spindle.
Polygon command has been issued for synchronized tapping spindle.
Spindle is being used as spindle/C axis.
Remedy
Cancel the C axis command.
Cancel the polygon machining command.
Cancel the C axis with servo OFF.
25
1021
1022
1023
1024
1025
1026
IB-1501279-H