Disp. Sysno; Workshift Invalid; Plc_Opemsg0; Remote Comm Enable - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#11055

Disp. sysno

Specify how many part systems to display on a screen.
0
1 or greater: The number specified by this parameter serves as that of the part systems to display.
(Note) The setting range differs according to the NC model.
---Setting range---
0 to 8
(PR) #11056

Workshift invalid

Set this parameter to 1 if you wish to disable the workpiece coordinate system shift function.
0: Enable the workpiece coordinate shift function
1: Disable the workpiece coordinate shift function
(PR) #11058

plc_opemsg0

Set the No. of F device to specify the displayed operator message.
Device specified with this parameter is treated as No.1, and displays up to 4 operator messages correspond-
ing to F device that is ON.
This parameter is valid when #6455/bit3 is 0.
(Note 1) Use from F1024 when 0 is set.
(Note 2) Set the device No. to be a multiple of 32. When other value is input, a setting error occurs.
---Setting range---
0 to 2016
(PR) #11059

Remote comm enable

[M8]
Select whether to enable the remote communication.
0: Disabled
1: Enabled
[C80]
Not used.
(PR) #11060 Screen theme color
Select the screen theme colors.
This selection affects the colors of the entire screen.
0: Standard colors (gray tone)
1: Blue tone
(PR) #11061 Num of EcoMonitors
[M8]
Specify how many EcoMonitorLight units (an energy meter made by Mitsubishi Electric for measuring the
consumption and regeneration) are connected to the CNC.
---Setting range---
0 to 16
Default 0
[C80]
Not used.
IB-1501279-H
: The same number as that of the enabled part systems
For the number of part systems displaying in the operating state, follow this parameter setting.
Number of part systems to display
Workpiece coordinate system shift OFF (For L system
only)
Operator messages display device
Remote connect enabled
Select screen theme colors
The Number of EcoMonitorLight connected to CNC
462