Mitsubishi Electric M800 Series Manual page 417

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1238 set10
bit0: Switch G36 function
Select the function, the automatic tool length measurement or arc thread cutting (CCW), to be applied to G36
when the G code system 6 or 7 is selected.
0: Automatic tool length measurement
1: Arc thread cutting (CCW)
bit3: Ignoring input from RIO
Select whether to ignore the input from RIO.
0: Output the input from RIO to the device X.
1: Ignore the input from RIO, and not output it to X device.
(X000 to X0FF, X100 to X1FF and X200 to X2BF)
* Normally set this parameter to "0".
* The devices X2C0 to X2FF are used for the handle pulse input and board reset from the operation panel I/
O unit card (HN391/HN392), thus are excluded from the target.
bit6: Switch absolute position detection alarm
Select the output destination of the absolute position detection alarm.
0: NC alarm 4 (AL4)
1: NC alarm 5 (AL5)
(Note) The absolute position detection alarm is listed in the alarm history regardless of this parameter setting.
bit7: Switch operation alarm
Select whether to enable the NC alarm 5 (AL5) signal output.
0: Disable NC alarm 5 (AL5)
All operation alarms will be output to NC alarm 4 (AL4).
1: Enable NC alarm 5 (AL5)
The following operation alarms will be output to NC alarm 5 (AL5), not to NC alarm 4 (AL4).
External interlock axis found (M01 0004)
Cutting override zero (M01 0102)
External feedrate zero (M01 0103)
Block start interlock (M01 0109)
Cutting block start interlock (M01 0110)
Interference check disabled (M01 0200)
Cutting interlock for spindle-spindle polygon (G51.2) (M01 1033)
The above alarms are not recorded in the alarm history regardless of the setting value of this parameter.
IB-1501279-H 400