M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P411
Illegal modal G111
Details
G111 was issued during milling mode.
G111 was issued during nose R compensation mode.
G111 was issued during constant surface speed.
G111 was issued during mixed control (cross axis control).
G111 was issued during fixed cycle.
G111 was issued during polar coordinate interpolation.
G111 was issued during cylindrical interpolation mode.
Remedy
Before commanding G111, cancel the following commands.
Milling mode
Nose R compensation
Constant surface speed
Mixed control (cross axis control)
Fixed cycle
Polar coordinate interpolation
Cylindrical interpolation
P412
No spec: Axis name switch
Details
Axis name switch (G111) was issued though it is out of specifications.
Remedy
Check the specifications.
P420
No spec: Para input by program
Details
Parameter input by program (G10) was commanded though it is out of specifications.
Remedy
Check the specifications.
P421
Parameter input error
Details
The specified parameter No. or set data is illegal.
An illegal G command address was input in parameter input mode.
A parameter input command was issued during fixed cycle modal or nose R compensation.
G10L50, G10L70, G10L100, G11 were not commanded in independent blocks.
Remedy
Correct the program.
P422
Tool/Work shape input error
Details
G10 L100, G10 L101 or G11 has been given together with any other command in a block.
Address P or T has been omitted from G10 L100.
Address C has been omitted from G10 L101.
Remedy
Correct the program.
145
IB-1501279-H