Mitsubishi Electric M800 Series Manual page 415

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
bit6: Initialization of drawing in graphic check
[M8]
Select whether to initialize the workpiece drawing automatically when you change any data in the 3D check
workpiece setup screen.
0: Initialize the workpiece drawing (conventional specifications)
1: Not initialize the workpiece drawing
Note that if you change the workpiece shape or dimensions, the workpiece drawing is automatically reset,
irrespective of this parameter.
[C80]
Not used.
bit7: Disable switching of graphic check method
[M8]
Select whether to enable or disable switching of the 3D check method.
0: Enable
1: Disable
If you choose Disable, the last selected check method remains selected.
[C80]
Not used.
#1232 set04
bit0: Exclude acceleration/deceleration in load monitor
Select whether or not to exclude acceleration/deceleration when detecting the load in load monitoring.
0: Acceleration/Deceleration is included
1: Acceleration/Deceleration is excluded
(Note) When "Exclude acceleration/deceleration in load monitor" ("#1232 set04/bit0") is enabled, "Spindle
function 8" ("#13228 SP228/bit2") needs to be set to "1" (load display, high-cycle motor output effective val-
ue).
bit5: Actual load selection
Load fluctuation due to speed change is excluded from the actual load.
0: Disable
1: Enable
(Note) When "Actual load selection" ("#1232 set04/bit5") is enabled, "Spindle function 8" ("#13228 SP228/
bit2") needs to be set to "1" (load display, high-cycle motor output effective value).
#1233 set05
When not using, set to "0".
#1234 set06
bit3: Interlock when tap retract enabled
Select whether to enable automatic/manual interlock for the part system with "Tap retract enable" signal ON.
0: Interlock all the axes
1: Disable the interlock
IB-1501279-H 398