Mitsubishi Electric M800 Series Manual page 473

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1960 Ext Unit1 Gateway
[M8]
Specify the gateway of the field network communication expansion unit installed in the slot EXT3 (or EXT1
for M80/M800S/E80).
---Setting range---
0.0.0.0 to 255.255.255.255
(PR) #1961 Ext Unit2 IP Addr
[M8]
Specify the IP address of the field network communication expansion unit installed in the slot EXT4 (or EXT2
for M80/M800S/E80).
---Setting range---
0.0.0.0 to 255.255.255.255
(PR) #1962 Ext Unit2 Sub mask
[M8]
Specify the subnet mask of the field network communication expansion unit installed in the slot EXT4 (or
EXT2 for M80/M800S/E80).
---Setting range---
0.0.0.0 to 255.255.255.255
(PR) #1963 Ext Unit2 Gateway
[M8]
Specify the gateway of the field network communication expansion unit installed in the slot EXT4 (or EXT2
for M80/M800S/E80).
---Setting range---
0.0.0.0 to 255.255.255.255
(PR) #11001 APC type
Set the type of screen displayed with the pallet program registration screen.
0: Standard pallet registration screen
1: Pallet 4-page registration screen
(PR) #11002 Valid pallet num
Set the number of pallets validated on the pallet program registration screen.
---Setting range---
2 to 12 (Interpreted as 2 when 0 is set.)
(PR) #11003 APLC valid
Temporarily disable APLC.
Normally set "1".
0: Disable
1: Enable
(PR) #11004 PLCauto-run enable
[M8]
Select starting condition of the built-in PLC.
0: Start PLC after NC screen startup
1: Start PLC at NC startup
(Note) When standard NC screen is not used, set "1".
[C80]
Not used.
IB-1501279-H
Field network communication expansion unit: gateway
1
Field network communication expansion unit: IP ad-
dress 2
Field network communication expansion unit: subnet
mask 2
Field network communication expansion unit: gateway
2
APC screen display type selection
Number of pallets setting
APLC valid
PLC automatic startup valid
456