Inclined Face Coord Illegal; G68.2P10 Surface Not Defined; Tool Axis Dir Ctrl Cmp Amt 0; Tool Axis Dir Ctrl Axis Illeg - Mitsubishi Electric M800 Series Manual

Hide thumbs Also See for M800 Series:

Table of Contents

M800/M80/E80/C80 Series Alarm/Parameter Manual

12 Program Errors (P)

Inclined face coord illegal

Impossible to define an inclined surface with the values you specified.

Check the program.

The coordinate system for the machining surface selected with G68.2P10 has not been defined.

Set the machining surface so that the coordinate system can be defined.

When the tool axis direction control type 2 (G53.6) was commanded, a tool length compensation No. whose

compensation amount is 0 was commanded.

Correct the program. Set the tool length compensation amount, or command a tool length compensation

No. whose compensation amount is not 0.

The command was issued with an angle with which tool axis direction control of 4-axis configuration is not avail-

Check the feature coordinate system defined in inclined surface machining command.

No spec: Simple inclined face

Simple inclined surface machining is not included in the specifications.

Check the specifications.

No spec: Direct command mode

G05 P4 was commanded while direct command mode option is OFF.

Check the specifications.

Invalid during dir cmnd mode

A G code other than G05 P0 was commanded in direct command mode.

A sequence No. command, F code command, MSTB command or variable command was issued.

A corner chamfering command or corner R command was issued.

A travel command was issued to an axis that had not been command in the G05 P4 block.

Check the program.

Dir cmnd mode cmnd invalid

G05 P4 was commanded in a modal where direct command mode is not available.

Check the program.

IB-1501279-H

Show Quick Links

Table of Contents

C80 series M80 series E80 series