Ot_Prechktype; Sbs_Name; Vblaccpreint; Sfilt2_Tol - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#12058

OT_prechkTYPE

[M8]
Select whether to enable or disable the stroke check before travel for skip (G31 or G31.n) and automatic tool
length measurement (G37).
0: Disable
1: Enable
(Note) This parameter is enabled when #12057=1 and the option "Stroke check before travel" is ON.
[C80]
Not used.
#12059

SBS_name

Specify each sub part system name.
This name is displayed when the part system acts as a sub part system.
---Setting range---
A combination of a maximum of four alpha-numeric characters
#12060

VblAccPreInt

Select whether to enable variable-acceleration pre-interpolation acceleration/deceleration control while high-
accuracy control is ON.
0: Pre-interpolation acceleration/deceleration
(Apply the acceleration rate that is determined by G1bF and G1btL and is common for all the axes)
1: Variable-acceleration pre-interpolation acceleration/deceleration
(Apply the acceleration rate that is determined by G1bFx and G1btLx for each axis)
(Note) Variable-acceleration pre-interpolation acceleration/deceleration is a function available under SSS
control. To enable this function, set "#8090 SSS ON" to 1.
#12070

Sfilt2_tol

Specify the time constant of the filter that smoothes out fluctuations in acceleration under the tolerance con-
trol.
Basically set to 0.
---Setting range---
0 to 200 (ms)
(PR) #12071-12078
Specify the axis address to be given in an arbitrary axis exchange command for the part system.
(Note 1) This parameter is disabled when the arbitrary axis exchange function is unused.
(Note 2) Do not give an identical name to two or more of the parameters adr_abs[1] to adr_abs[8].
(Note 3) Do not leave any unspecified parameter in the middle between adr_abs[1] and [8].
(Note 4) Set the addresses of adr_abs[ ] in the same order as of the axis names (#1013 axname). Note that
you can set a nonexistent axis name in the middle.
(Note 5) If there are 9 or more control axes per part system, specify the axis address that is programmed
based on the basic axis configuration.
---Setting range---
Axis address such as X, Y, Z, U, V, W, A, B and C
(PR) #12079-12086
Specify the incremental command address for each of the axes to be used in an arbitrary axis exchange com-
mand.
(Note 1) This parameter is disabled when the arbitrary axis exchange function is unused.
(Note 2) There is no need to set this parameter when command type (absolute or incremental) is not distin-
guished by the axis address (when #1076 ABS/INC address=0).
(Note 3) Do not give an identical name to two or more of the parameters adr_inc[1] to adr_inc[8].
If there is any overlap, priority is given in the ascending order (adr_inc[1] to adr_inc[8]).
---Setting range---
Axis address such as X, Y, Z, U, V, W, A, B and C
IB-1501279-H
adr_abs[1]-[8]
adr_inc[1]-[8]
Stroke check before travel for skip and automatic tool
length measurement
Sub part system name
Variable-acceleration pre-interpolation acceleration/de-
celeration ON
Tolerance control: Soft acceleration/deceleration filter
2
Command address for arbitrary axis exchange
Incremental command address for arbitrary axis ex-
change
370