ABB RELION REX640 Technical Manual page 187

1MRS759142 F
Parameter Values (Range)
Value low limit –10000.0...10000.0
Value low low limit –10000.0...10000.0
Value deadband 100...100000
Sensor fault level 0...3
Table 111: Input-specific settings for RTD
Parameter Values (Range)
Input mode
1=Not in use
2=Resistance
10=Pt100
11=Pt250
20=Ni100
21=Ni120
22=Ni250
30=Cu10
Input maximum 0...4000
Input minimum 0...4000
Value unit
1=Dimensionless
5=Ampere
23=Degrees celsius
30=Ohm
Value maximum –10000.0...10000.0
Value minimum –10000.0...10000.0
Val high high limit –10000.0...10000.0
Value high limit –10000.0...10000.0
Value low limit –10000.0...10000.0
Value low low limit –10000.0...10000.0
Value deadband 100...100000
Update interval
0=No delay
1=10 ms
2=50 ms
3=100 ms
Table 112: Output-specific settings for mA
Parameter Values (Range)
Output mode
1=Not in use
Table continues on the next page
REX640
Technical Manual
Unit Step Default
–10000
–10000
1000
mA 0
Unit Step Default
1=Not in use
Ω
Ω
1=Dimensionless
10000
–10000
10000
10000
–10000
–10000
1000
0
Unit Step Default
1=Not in use
Basic functions
Description
Output value low warning limit
for supervision
Output value low alarm limit for
supervision
Deadband configuration value
for integral calculation. (percent-
age of difference between min
and max as 0,001 % s)
Below this current level sensor
fault is activated
Description
Analogue input mode
Maximum analogue input value
for mA or resistance scaling
Minimum analogue input value
for mA or resistance scaling
Selected unit for output value
format
Maximum output value for scal-
ing and supervision
Minimum output value for scal-
ing and supervision
Output value high alarm limit for
supervision
Output value high warning limit
for supervision
Output value low warning limit
for supervision
Output value low alarm limit for
supervision
Deadband configuration value
for integral calculation. (percent-
age of difference between min
and max as 0,001 % s)
Value update interval
Description
Analog output mode
187