ABB RELION REX640 Technical Manual page 365

1MRS759142 F
Parameter Values (Range)
3=ANSI Norm. inv.
5=ANSI Def. Time
9=IEC Norm. inv.
10=IEC Very inv.
12=IEC Ext. inv.
15=IEC Def. Time
17=Programmable
Operate delay time 40...300000
Characteristic an- -179...180
gle
Max forward angle 0...90
Max reverse angle 0...90
Min forward angle 0...90
Min reverse angle 0...90
Table 407: DPHHPDOC Group settings (Advanced)
Parameter Values (Range)
Type of reset curve
1=Immediate
2=Def time reset
3=Inverse reset
Voltage Mem time 0...3000
Pol quantity
1=Self pol
4=Neg. seq. volt.
5=Cross pol
7=Pos. seq. volt.
Table 408: DPHHPDOC Non group settings (Basic)
Parameter Values (Range)
Operation
1=on
5=off
Curve parameter A 0.0086...120.0000
Curve parameter B 0.0000...0.7120
Curve parameter C 0.02...2.00
Curve parameter D 0.46...30.00
Curve parameter E 0.0...1.0
Num of start pha-
1=1 out of 3
ses
2=2 out of 3
REX640
Technical Manual
Unit Step
ms 10
deg 1
deg 1
deg 1
deg 1
deg 1
Unit Step
ms 1
Unit Step
0.0001
0.0001
0.01
0.01
0.1
Protection functions
Default Description
40 Operate delay time
60 Characteristic an-
gle
80 Maximum phase
angle in forward di-
rection
80 Maximum phase
angle in reverse di-
rection
80 Minimum phase an-
gle in forward di-
rection
80 Minimum phase an-
gle in reverse direc-
tion
Default Description
1=Immediate Selection of reset
curve type
40 Voltage memory
time
5=Cross pol Reference quantity
used to determine
fault direction
Default Description
1=on Operation Off / On
28.2000 Parameter A for
customer program-
mable curve
0.1217 Parameter B for
customer program-
mable curve
2.00 Parameter C for
customer program-
mable curve
29.10 Parameter D for
customer program-
mable curve
1.0 Parameter E for
customer program-
mable curve
1=1 out of 3 Number of phases
required for oper-
ate activation
365