ABB ACS560 Firmware Manual page 107

Terminal sizes
• (frames R0...R8): 0.14...1.5 mm
• Tightening torques: 0.5...0.6 N·m (0.4 lbf·ft)
Notes
1)
Current [0(4)...20 mA, R
input as selected with parameter 12.15 AI1 unit selection.
2)
Current [0(4)...20 mA, R
input as selected with parameter 12.25 AI2 unit selection.
3)
Total load capacity of the auxiliary voltage output +24V (X2:10) = 6.0 W (250 mA /
24 V). User can use this source for either of the I/O connections (DI1... DI2- RO1 or
DI3...DI6 - RO2 RO3).
~
4)
The constant speed are set based on the combination of sources as follows:
Source defined by
par.22.22
0
1
5)
The speed reference ramp is set based on the combination of sources as follows:
DI5 Ramp set
0 1
1 2
6)
Connected with jumpers at the factory.
7)
Ground the outer shield of the cable 360 degrees under the grounding clamp on
the grounding shelf for the control cables.
8)
Input signal
9)
Output signal
10)
For R0...R2 frames only
For information on cable connection and drive operation, see Control Connections in
the hardware manual (3AXD50000044998).
2
(all terminals)
< 500 ohm] or voltage [ 0(2)...10 V, R
in
= 100 ohm] or voltage [ 0(2)...10 V, R
in
Source defined by
0
0
Parameters
Vector control (default)
23.12 Acceleration time 1
23.13 Deceleration time 1
23.14 Acceleration time 2
23.15 Deceleration time 2
par.22.23 Constant speed active
Set speed through AI1
Constant speed 1
Control macros 107
> 200 kohm]
in
> 200 kohm]
in