ABB ACS560 Firmware Manual page 185

No. Name/Value
Supervision 1
Supervision 2
Supervision 3
Start delay
RO/DIO control
word bit0
RO/DIO control
word bit1
RO/DIO control
word bit2
PFC1
PFC2
PFC3
PFC4
Event word 1
User load curve
RO/DIO control
word
Other [bit]
10.25 RO1 ON delay
Status of selected
source
RO status
t = 10.25 RO1 ON delay
On
t = 10.26 RO1 OFF delay
Off
0.0 ... 3000.0 s
10.26 RO1 OFF delay
0.0 ... 3000.0 s
10.27 RO2 source
Description
Bit 0 of 32.01 Supervision status
Bit 1 of 32.01 Supervision status
Bit 2 of 32.01 Supervision status
Bit 13 of 06.17 Drive status word 2
Bit 0 of 10.99 RO/DIO control word
Bit 1 of 10.99 RO/DIO control word
Bit 2 of 10.99 RO/DIO control word
Bit 0 of 76.01 PFC status
Bit 1 of 76.01 PFC status
Bit 2 of 76.01 PFC status
Bit 3 of 76.01 PFC status
Event word 1 = 1 if any bit of
170) is 1, that is, if any warning, fault or pure event that has
been defined with parameters
Bit 3 (Outside load limit) of
page 292).
Maps to corresponding bit in parameter
word. For example, Bit 0 of
controls RO1, Bit 1 of 10.99 RO/DIO control word
RO2, and so on.
Source selection (see Terms and abbreviations
Defines the activation delay for relay output RO1.
t t
On Off
Activation delay for RO1.
Defines the deactivation delay for relay output RO1. See
parameter 10.25 RO1 ON
Deactivation delay for RO1.
Selects a drive signal to be connected to relay output RO2.
For the available selections, see parameter
source.
(see page 266).
(see page 266).
(see page 266).
(see page 175).
(see page 186).
(see page 186).
(see page 186).
(see page 345).
(see page 345).
(see page 345).
(see page 345).
04.40 Event word 1
04.43...04.71 is on.
37.01 ULC output status word
10.99 RO/DIO control
10.99 RO/DIO control word
on page 162). -
t
On
delay.
10.24 RO1
Parameters 185
Def/FbEq16
33
34
35
39
40
41
42
45
46
47
48
(see page 53
(see 61
62
controls
0.0 s
1
0
1
0
Time
t
Off
10 = 1 s
0.0 s
10 = 1 s
Running