ABB ACS560 Firmware Manual page 23

Navigate to the Options menu
frequency/speed reference. Use
the value.
Press (OK) to accept the new setting, or press
(Back) to go back to the previous view without making
changes.
Press Start .
Make sure that the motor is running in the required direction. The direction symbol is
displayed in the home page. The forward direction is indicated by
direction is indicated by
Press Stop .
If you want to make a backup of the settings made so
far, navigate to Main menu
You can restore and back up the data between drive and
panel.
Select the option and press
(Back) to go back to the previous view without
making changes.
The first start setup is complete and the drive is ready for
use. The home view displays the values of selected
signals.
Macro/start-stop reference, ramp, and limit settings
You can make any additional changes to the macro, ramp, and limits, if required.
Macro settings
Navigate to the Main menu
connection .
Select the desired macro. Use
cursor left and right.
Press (OK) to accept or press
back to the previous view without making changes.
Notes:
• Changing the macro resets all settings to the default values of the selected macro and
updates the I/O signals used in the drive.
You can see the currently used I/O signals in the
• All macros, except the ABB standard (vector) and Pharma macro, use scalar motor
control by default.You can change the motor control mode in the Motor data
Start-up, control with I/O and ID run 23
and set the
and to change
.
and select Backup
(OK) to accept or press
2 – Additional settings
and select I/O
and to move the
(Back) to go
0.0Hz
0
and the reverse
.
Loc
I
0.00
Hz
menu.
0
10.0 Hz
PID
.