ABB ACS560 Firmware Manual page 293

No. Name/Value
Warning/Fault
37.04 ULC underload
actions
Disabled
Warning
Fault
Warning/Fault
37.11 ULC speed table
point 1
-30000.0...30000.0
rpm
37.12 ULC speed table
point 2
-30000.0...30000.0
rpm
37.13 ULC speed table
point 3
-30000.0...30000.0
rpm
37.14 ULC speed table
point 4
-30000.0...30000.0
rpm
37.15 ULC speed table
point 5
-30000.0...30000.0
rpm
Description
The drive generates an
signal has been continuously over the overload curve for a
time defined by parameter
The drive generates a 8002 ULC underload fault
has been continuously over the overload curve for a time
defined by parameter 37.41 ULC overload
Selects an action taken if the signal stays under the
underload curve for a defined time.
No warnings or fault generated.
The drive generates an
signal has been continuously under the underload curve for a
time defined by parameter
The drive generates a 8001 ULC underload fault
has been continuously under the underload curve for a time
defined by parameter 37.42 ULC underload
The drive generates an
signal has been continuously under the underload curve for a
time defined by parameter
The drive generates an
signal has been continuously under the underload curve for a
time defined by parameter
Defines the first of the five speed points on the X-axis of the
user load curve.
The values of the parameters must satisfy: -30000.0 rpm <
37.11 ULC speed table point 1
2 < 37.13 ULC speed table point 3
point 4 < 37.15 ULC speed table point 5
Speed points are used if parameter
is set to Vector or if 99.04 Motor control mode
and the reference unit is rpm.
Speed.
Defines the second speed point.
See parameter 37.11 ULC speed table point
Speed.
Defines the third speed point.
See parameter 37.11 ULC speed table point
Speed.
Defines the fourth speed point.
See parameter 37.11 ULC speed table point
Speed.
Defines the fifth speed point.
See parameter 37.11 ULC speed table point
Speed.
A8BE ULC overload warning
37.41 ULC overload
timer.
A8BF ULC underload warning
37.42 ULC underload
timer.
A8BF ULC underload warning
37.42 ULC underload
A8BF ULC underload warning
37.42 ULC underload
< 37.12 ULC speed table point
< 37.14 ULC speed table
< 30000.0 rpm.
99.04 Motor control mode
is set to
1.
1.
1.
1.
Parameters 293
Def/FbEq16
if the 3
timer.
if the signal
Disabled
0
if the 1
timer.
if the signal 2
if the 3
timer.
if the
timer.
150.0 rpm
Scalar
1 = 1 rpm
750.0 rpm
1 = 1 rpm
1290.0 rpm
1 = 1 rpm
1500.0 rpm
1 = 1 rpm
1800.0 rpm
1 = 1 rpm