Setting The Drive Control Parameters - ABB ACS560 Firmware Manual

Fieldbus control through the embedded fieldbus interface (EFB) 441
Parameter
58.06 Communication
control
The new settings will take effect when the drive is powered up the next time, or when
they are validated by parameter

Setting the drive control parameters

After the embedded fieldbus interface has been set up, check and adjust the drive
control parameters listed in the table below. The Setting for fieldbus control column
gives the value or values to use when the embedded fieldbus signal is the desired
source or destination for that particular drive control signal. The
Function/Information column gives a description of the parameter.
Parameter
CONTROL COMMAND SOURCE SELECTION
20.01 Ext1
commands
20.06 Ext2
commands
SPEED REFERENCE SELECTION
22.11 Ext1 speed ref1 EFB ref1
22.18 Ext2 speed ref1 EFB ref1
TORQUE REFERENCE SELECTION
26.11 Torque ref1
source
26.12 Torque ref2
source
FREQUENCY REFERENCE SELECTION
28.11 Ext1 frequency
ref1
Setting for
fieldbus control
Refresh settings
58.06 Communication control (Refresh
Setting for
fieldbus control
Embedded fieldbus
Embedded fieldbus
EFB ref1
EFB ref1
EFB ref1
Function/Information
Validates the settings of the configuration
parameters.
Function/Information
Selects fieldbus as the source for the start
and stop commands when EXT1 is selected
as the active control location.
Selects fieldbus as the source for the start
and stop commands when EXT2 is selected
as the active control location.
Selects a reference received through the
embedded fieldbus interface as speed
reference 1.
Selects a reference received through the
embedded fieldbus interface as speed
reference 2.
Selects a reference received through the
embedded fieldbus interface as torque
reference 1.
Selects a reference received through the
embedded fieldbus interface as torque
reference 2.
Selects a reference received through the
embedded fieldbus interface as frequency
reference 1.
settings).