ABB ACS560 Firmware Manual page 118

118 Control macros
Terminal sizes
• (frames R0...R8): 0.14...1.5 mm
• Tightening torques: 0.5...0.6 N·m (0.4 lbf·ft)
Notes
1)
The signal source is powered externally. See the manufacturer's instructions. To
use sensors supplied by the drive aux. voltage output, see chapter Electrical
installation, section Connection examples of two-wire and three-wire sensors in the
Hardware manual of the drive
2)
If Constant frequency is activated it overrides the reference from the PID controller
output.
3)
The internal setpoint are set based on the combination of sources as follows:
Source defined
by par. 40.19
DI2
0
1
0
1
4)
Ground the outer shield of the cable 360 degrees under the grounding clamp on
the grounding shelf for the control cables.
5)
Connected with jumpers at the factory.
6)
Total load capacity of the auxiliary voltage output +24V (X2:10) = 6.0 W (250 mA /
24 V). User can use this source for either of the I/O connections (DI1... DI2- RO1 or
DI3...DI6 - RO2 RO3).
~
7)
Input signal
8)
Output signal
9)
For R0...R2 frames only
In addition, below inputs are set automatically as follows:
Parameter No.
20.01
23.11
For information on cable connection and drive operation, see Control Connections in
the Hardware manual (3AXD50000044998).
2
(all terminals)
Source defined
by par. 40.20
DI3
0
0
1
1
Name
(Input/Setting)
Ext1 commands
Ramp set selection
Internal setpoint active
Setpoint source: AI1
Set 1 internal setpoint 1
Set 1 internal setpoint 2
Set 1 internal setpoint 3
Value
1= In1 Start
0 = Acc/Dec time 1