ABB ACS560 Firmware Manual page 204

204 Parameters
No. Name/Value
In1 Start fwd; In2
Start rev
In1P Start; In2 Stop The sources of the start and stop commands are selected by
In1P Start; In2 Stop;
In3 Dir
Description
The source selected by
start signal; the source selected by
the reverse start signal. The state transitions of the source
bits are interpreted as follows:
State of source 1
(20.08)
0
0 -> 1 (20.07 = Edge)
1 (20.07 = Level)
0
1
parameters 20.08 Ext2 in1 source
The state transitions of the source bits are interpreted as
follows:
State of source 1
(20.08)
0 - > 1
Any
Notes:
• Parameter 20.07 Ext2 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1 source
The source selected by
direction. The state transitions of the source bits are
interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
1
0 - > 1
1
Any 0
Notes:
• Parameter 20.07 Ext2 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
20.08 Ext2 in1 source is the forward
20.09 Ext2 in2 source
State of source 2
(20.09)
0
0
0 -> 1 (20.07 = Edge)
1 (20.07 = Level)
1
and 20.09 Ext2 in2
State of source 2
(20.09)
1
0
has no effect with
and 20.09 Ext2 in2
20.10 Ext2 in3 source determines the
State of
source 3
(20.10)
0 Start forward
1 Start reverse
Any
has no effect with
Def/FbEq16
3
is
Command
Stop
Start forward
Start reverse
Stop
4
source.
Command
Start
Stop
5
source.
Command
Stop