ABB ACS560 Firmware Manual page 355

No. Name/Value
English
Hindi (India)
96.02 Pass code
0...99999999
96.03 Access level status
0b0000...0b1111
Bit Name
0 End user
1 Service
2 Advanced programmer
3 Reserved
4 Long menu
5...9 Reserved
10 Override parameter lock
11 OEM access level 1
12 OEM access level 2
13 OEM access level 3
14 Parameter lock
15 Reserved
0b0000...0b1111
96.04 Macro select
Done
ABB standard
ABB standard
(vector)
3-wire
Motor
potentiometer
Description
English.
Hindi.
Pass codes can be entered into this parameter to activate
further access levels (see parameter
status) or to configure the user lock.
Entering "358" toggles the parameter lock, which prevents the
changing of all other parameters through the control panel or
the Drive composer PC tool.
Entering the user pass code (by default, "10000000") enables
parameters 96.100...96.102, which can be used to define a
new user pass code and to select the actions that are to be
prevented.
Entering an invalid pass code will close the user lock if open,
ie. hide parameters 96.100...96.102. After entering the code,
check that the parameters are in fact hidden.
Note: You must change the default user pass code to
maintain a high level of cybersecurity. Store the code in a safe
place – the protection cannot be disabled even by ABB if the
code is lost.
See also section User lock
Pass code.
Shows which access levels have been activated by pass
codes entered into parameter
Active access levels.
Selects the control macro. See chapter
101) for more information.
After a selection is made, the parameter reverts automatically
to Done.
Macro selection complete; normal operation.
Factory macro (see page 102). For scalar motor control.
ABB standard (vector) macro (see page 105). For vector
motor control.
3-wire macro (see page 108)
Motor potentiometer macro (see page 111).
96.03 Access level
(page 96).
96.02 Pass code.
Control macros
Parameters 355
Def/FbEq16
1033
2052
0
-
0b0000
1=1
-
(page Done
0
1
17
13