Pfc Configuration - ABB ACS560 Firmware Manual

No. Name/Value
inHg
kCFM
inWC
GPM
gal/m
in wg
MPa
ftWC
76

76 PFC configuration

76.01 PFC status
Bit Name
0 PFC 1 running
1 PFC 2 running
2 PFC 3 running
3 PFC 4 running
4...15 Reserved
0b0000...0b1111
76.02 PFC system status
PFC disabled
PFC enabled (not
started)
SPFC enabled (not
started)
MPFC enabled
Invalid configuration -
PFC inactive (local
control)
PFC inactive
(invalid operation
mode)
Drive motor
interlocked
All motors
interlocked
Description
inHg
kCFM
inWC
GPM
gal/m
in wg
MPa
ftWC
PFC (Pump and fan control) and Autochange configuration
parameters. See also section
macro on page 125.
Displays the running/stopped status of the PFC motors.
PFC1, PFC2, PFC3 and PFC4 always correspond to the
1st...4th motor of the PFC system. If
auxiliary PFC auxiliary PFC is set to
represents the motor connected to the drive and PFC2 the
first auxiliary motor (the 2nd motor of the system). If
set to All motors, PFC1 is the first motor, PFC2 the 2nd. The
drive can be connected to any of these motors depending on
the Autochange functionality.
Value
0 = Stop, 1 = Start
0 = Stop, 1 = Start
0 = Stop, 1 = Start
0 = Stop, 1 = Start
Status of the PFC relay outputs.
Displays the status of the PFC system in text form. Provides a
quick PFC system overview, e.g. if the parameter is added to
the Home view on the control panel.
-
-
-
-
-
-
-
-
Pump and Fan Control (PFC)
76.74 Autochange
Aux motors only, PFC1
76.74
Parameters 345
Def/FbEq16
24
25
26
27
28
29
30
31
0b0000
is
1 = 1
PFC disabled
0
1
2
3
4
5
6
7
8