ABB ACS560 Firmware Manual page 62

62 Program features
State name
BRAKE CLOSING DELAY
BRAKE CLOSED
State change conditions (
1 Brake control disabled (parameter
2 06.11 Main status
3 Brake has been requested to open.
4 44.08 Brake open delay
5 Brake has been requested to close.
6 Motor speed is below closing speed
7 44.13 Brake close delay
8 Brake has been requested to open.
9 Brake control enabled (parameter
Closing conditions have been met. The open signal is deactivated
b0 → 0). The ramp-down request is maintained
control status
control status b3 = 1). The brake logic will remain in this state until
close delay has elapsed.
At this point, the logic proceeds to
The brake is closed
necessarily modulating.
)
n
44.06 Brake control enable
word, bit 2 = 0.
has elapsed.
44.14 Brake close
has elapsed.
44.06 Brake control enable
Description
BRAKE CLOSED
(44.01 Brake control status
→ 0).
level.
→ 1).
(44.01 Brake
(44.01 Brake
44.13 Brake
state.
b0 = 0). The drive is not