ABB ACS560 Firmware Manual page 205

No. Name/Value
In1P Start fwd; In2P
Start rev; In3 Stop
Control panel
Fieldbus A
Embedded fieldbus
20.07 Ext2 start trigger
type
Edge
Level
20.08 Ext2 in1 source
20.09 Ext2 in2 source
20.10 Ext2 in3 source
20.11 Run enable stop
mode
Coast
Ramp
Torque limit
Description
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1
20.10 Ext2 in3 source. The source selected by
source determines the direction. The state transitions of the
source bits are interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
Any
0 - > 1
Any
Any Any
Note: Parameter 20.07 Ext2 start trigger type
with this setting.
The start and stop commands are taken from the control
panel (or PC connected to the panel connector).
The start and stop commands are taken from fieldbus adapter
A.
Note: Set also 20.07 Ext2 start trigger type
The start and stop commands are taken from the embedded
fieldbus interface.
Note: Set also 20.07 Ext2 start trigger type
Defines whether the start signal for external control location
EXT2 is edge-triggered or level-triggered.
Note: This parameter is not effective if a pulse-type start
signal is selected. See the descriptions of the selections of
parameter 20.06 Ext2 commands.
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
For the available selections, see parameter
source.
Selects source 2 for parameter
For the available selections, see parameter
source.
Selects source 3 for parameter
For the available selections, see parameter
source.
Selects the way the motor is stopped when the run enable
signal switches off.
The source of the run enable signal is selected by parameter
20.12 Run enable 1 source.
Stops by switching off the output semiconductors of the drive.
The motor coasts to a stop.
WARNING! If a mechanical brake is used, ensure it is
safe to stop the drive by coasting.
Stops along the active deceleration ramp. See parameter
group 23 Speed reference ramp
Stops according to torque limits (parameters
30.20).
source, 20.09 Ext2 in2 source
20.10 Ext2 in3
State of
source 3 Command
(20.10)
1 Start forward
1 Start reverse
0
has no effect
to Level.
to Level.
20.06 Ext2 commands.
20.03 Ext1 in1
20.06 Ext2 commands.
20.03 Ext1 in1
20.06 Ext2 commands.
20.03 Ext1 in1
on page 226.
30.19
Parameters 205
Def/FbEq16
6
and
Stop
11
12
14
Level
0
1
Always off
Always off
Always off
Coast
0
1
and 2