Summary Of Parameter Groups - ABB ACS560 Firmware Manual

Summary of parameter groups

Group
01 Actual values
03 Input references
04 Warnings and faults
05 Diagnostics
06 Control and status words
07 System info
10 Standard DI, RO
11 Standard DIO, FI, FO
12 Standard AI
13 Standard AO
19 Operation mode
20 Start/stop/direction
21 Start/stop mode
22 Speed reference selection
23 Speed reference ramp
25 Speed control
26 Torque reference chain
28 Frequency reference chain
30 Limits
31 Fault functions
32 Supervision
34 Timed functions
35 Motor thermal protection
36 Load analyzer
37 User load curve
40 Process PID set 1
41 Process PID set 2
43 Brake chopper
44 Mechanical brake control
45 Energy efficiency
46 Monitoring/scaling settings
47 Data storage
Contents
Basic signals for monitoring the drive.
Values of references received from various sources.
Information on warnings and faults that occurred last.
Various run-time-type counters and measurements related to drive
maintenance.
Drive control and status words.
Drive hardware and firmware information.
Configuration of digital inputs and relay outputs.
Configuration of the frequency input.
Configuration of standard analog inputs.
Configuration of standard analog outputs.
Selection of local and external control location sources and
operating modes.
Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings.
Speed reference selection; motor potentiometer settings.
Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
Speed controller settings.
Settings for the torque reference chain.
Settings for the frequency reference chain.
Drive operation limits.
Configuration of external events; selection of behavior of the drive
upon fault situations.
Configuration of signal supervision functions 1...6.
Configuration of the timed functions.
Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
Peak value and amplitude logger settings.
Settings for user load curve.
Parameter values for process PID control.
A second set of parameter values for process PID control.
Settings for the internal brake chopper.
Configuration of mechanical brake control.
Settings for the energy saving calculators.
Speed supervision settings; actual signal filtering; general scaling
settings.
Data storage parameters that can be written to and read from
using other parameters' source and target settings.
Parameters 163
Page
165
168
169
170
173
178
179
187
188
193
198
200
209
217
226
230
235
240
251
258
266
273
280
291
292
295
309
312
314
315
319
322