ABB ACS560 Firmware Manual page 22

22 Start-up, control with I/O and ID run
Refer to the motor nameplate for the following nominal value settings of the motor. Enter the
values exactly as shown on the motor nameplate.
Example of a nameplate of an induction (asynchronous) motor:
Navigate to Main menu
Set the motor nominal current:
• Use and
• Use and
Press (OK) to accept the new setting, or press
(Back) to go back to the previous view without making
changes.
Set the torque and motor Cos Φ, if needed. Motor
nominal cos Φ and nominal torque are optional.
• Use and
• Use and
Press (OK) to accept the new setting, or press
(Back) to go back to the previous view without making
changes.
Set the desired motor control mode. If Vector motor
control mode is selected, make sure that ID run is
performed. See ID run
Navigate to Options menu
direction.
and select Motor data
to move the cursor left and right.
to change the value.
to move the cursor left and right.
to change the value.
procedure.
 and set the
.
Scalar
3A
96.06
3.0
A
0.000Nm
Cos Φ
0.00
0.000Nm
Cos Φ
0.00
Scalar
4.7A
Loc
I
13.04
Hz
2.20kW
400.0V
U V W
U V W
2.20kW
400.0V
10.13.04Hz