Feedback Selection; Hw Configuration - ABB ACS560 Firmware Manual

352 Parameters
No. Name/Value
90

90 Feedback selection

90.03 Load speed
-32768.00 ...
32767.00 rpm
90.52 LoadSpeed filter
time
0...10000 ms
90.61 Gear numerator
-2147483648...
2147483647
90.62 Gear denominator
-2147483648...
2147483647
90.99 Load speed unit
No unit
rpm
m/s
m/min
ft/s
ft/min
95

95 HW configuration

95.01 Supply voltage
Automatic / not
selected
380...415 V
Description
Load feedback configuration.
Displays the estimated load speed.
Load speed =
90.62 Gear denominator
90.61 Gear numerator
Load speed.
Defines a filter time for load speed feedback
speed).
Load speed filter time.
Parameter 90.61 and 90.62
the motor and load speed.
90.61 Gear numerator
90.62 Gear denominator
Gear numerator (motor-side)
See parameter 90.61 Gear
Gear denominator (load - side)
Selects the unit for parameter
No unit
rpm
m/s
m/min
ft/s
ft/min
Various hardware-related settings.
Selects the supply voltage range. This parameter is used by
the drive to determine the nominal voltage of the supply
network. The parameter also affects the current ratings and
the DC voltage control functions (trip and brake chopper
activation limits) of the drive.
WARNING! An incorrect setting may cause the motor
to rush uncontrollably, or the brake chopper or resistor
to overload.
Note: The selections shown depend on the hardware of the
drive. If only one voltage range is valid for the drive in
question, it is selected by default.
No voltage range selected. The drive will not start modulating
before a range is selected, unless parameter
voltage limits is set to Enable, in which case the drive
estimates the supply voltage itself.
380...415 V
01.01 Motor speed
X
used
(90.03 Load
define a gear function between
Motor speed
=
Load speed
numerator.
90.03 Load speed.
95.02 Adaptive
Def/FbEq16
1 = 1 rpm
10 ms
1 = 1 ms
1
-
1
-
rpm
0
7
41
42
43
45
380...415 V
0
2