ABB ACS560 Firmware Manual page 46

46 Program features
The diagram below shows the behavior of speed and torque during the autotune
routine. In this example,
Initial torque + [25.38]
Initial torque
Initial speed + [25.39]
Initial speed
Notes:
• If the drive cannot produce the requested braking power during the routine, the
results will be based on the acceleration stages only, and not as accurate as with
full braking power.
• The motor will exceed the calculated maximum speed slightly at the end of each
acceleration stage.
Before activating the autotune routine
The prerequisites for performing the autotune routine are:
• The motor identification run (ID run) has been successfully completed
• Speed and torque limits (parameter group
• The drive has been started and is running in speed control mode.
After these conditions have been fulfilled, autotuning can be activated by parameter
25.33 (or the signal source selected by it).
Autotune modes
Autotuning can be performed in three different ways depending on the setting of
parameter 25.34. The selections Smooth,
torque reference should react to a speed reference step after tuning. The selection
Smooth will produce a slow but robust response;
25.40 is set to 2.
Normal
30 Limits) have been set
and Tight define how the drive
Tight will produce a fast response
t