ABB ACS560 Firmware Manual page 420

420 Fault tracing
Warning / Aux. code
(aux code visible only
Code
on assistant control
(hex)
panel and drive
composer)
A8B0 Signal supervision 1
(Editable message text)
Programmable warning:
32.06 Supervision 1 action
A8B1 Signal supervision 2
(Editable message text)
Programmable warning:
32.16 Supervision 2 action
A8B2 Signal supervision 3
(Editable message text)
Programmable warning:
32.26 Supervision 3 action
A8B3 Signal supervision 4
(Editable message text)
Programmable warning:
32.36 Supervision 4 action
A8B4 Signal supervision 5
(Editable message text)
Programmable warning:
32.46 Supervision 5 action
A8B5 Signal supervision 6
(Editable message text)
Programmable warning:
32.56 Supervision 6 action
A8B6 Current limit
A8BE ULC overload warning
A8BF ULC underload
warning
Cause
0003 Relay output 3
Warning generated by the
signal supervision function 1.
Warning generated by the
signal supervision function 2.
Warning generated by the
signal supervision function 3.
Warning generated by the
signal supervision function 4.
Warning generated by the
signal supervision function 5.
Warning generated by the
signal supervision function 6.
Motor actual current exceeded
the limit defined in parameter
30.17 Maximum
User load curve: Signal has
been too long over the
overload curve.
001 Overload occurred between
speed point 37.11 ULC speed
table point 1 and
speed table point
002 Overload occurred between
speed point 37.12 ULC speed
table point 2 and
speed table point
003 Overload occurred between
speed point 37.13 ULC speed
table point 3 and
speed table point
004 Overload occurred between
speed point 37.14 ULC speed
table point 4 and
speed table point
User load curve: Signal has
been too long under the
underload curve.
What to do
Select a different signal with parameter
10.30 RO3
Check the source of the warning
(parameter
Check the source of the warning
(parameter
Check the source of the warning
(parameter
Check the source of the warning
(parameter
Check the source of the warning
(parameter
Check the source of the warning
(parameter
Reduce the motor load. Check for any
jam or stall in motor.
current.
See parameter
actions.
Check the load.
37.12 ULC
2.
Check the load.
37.13 ULC
3.
Check the load.
37.14 ULC
4.
Check the load.
37.15 ULC
5.
See parameter
actions.
source.
32.07 Supervision 1 signal).
32.17 Supervision 2 signal).
32.27 Supervision 3 signal).
32.37 Supervision 4 signal).
32.47 Supervision 5 signal).
32.57 Supervision 6 signal).
37.03 ULC overload
37.04 ULC underload