Pfc Maintenance And Monitoring - ABB ACS560 Firmware Manual

No. Name/Value
76.83 PFC interlock 3
76.84 PFC interlock 4
76.95 Regulator bypass
control
Disable
Enable
Other [bit]
77
77 PFC maintenance
and monitoring
77.10 PFC runtime
change
Done
Set any PFC run
time
Reset PFC1 run
time
Reset PFC2 run
time
Reset PFC3 run
time
Reset PFC4 run
time
77.11 Pump/fan 1 running
time
0.00...42949672.95
h
77.12 Pump/fan 2 running
time
77.13 Pump/fan 3 running
time
77.14 Pump/fan 4 running
time
Description
See parameter 76.82 PFC interlock
See parameter 76.82 PFC interlock
Defines if direct-on-line pumps are automatically started and
stopped.
This setting can be used in applications with a low number of
sensors and low accuracy requirements.
Automatic starting and stopping is disabled.
Automatic starting and stopping is enabled.
Source selection (see Terms and abbreviations
PFC (Pump and fan control) maintenance and monitoring
parameters.
Enables the reset, or arbitrary setting, of
running time ... 77.14 Pump/fan 4 running
The parameter automatically reverts back to this value.
Enables the setting of 77.11 Pump/fan 1 running time
77.14 Pump/fan 4 running time
Resets parameter 77.11 Pump/fan 1 running
Resets parameter 77.12 Pump/fan 2 running
Resets parameter 77.13 Pump/fan 3 running
Resets parameter 77.14 Pump/fan 4 running
Running time counter of pump/fan 1. Can be set or reset by
parameter 77.10 Pump/fan 1 running
Time
See parameter 77.11 Pump/fan 1 running
See parameter 77.11 Pump/fan 1 running
See parameter 77.11 Pump/fan 1 running
Parameters 351
1.
1.
on page 162). -
77.11 Pump/fan 1
time.
...
to an arbitrary value.
time.
time.
time.
time.
time.
time.
time.
time.
Def/FbEq16
Available.
PFC motor is
available
Available.
PFC motor is
available
Disable
0
1
Done
0
1
2
3
4
5
0.00 h
1 = 1 h
0.00 h
0.00 h
0.00 h