ABB ACS560 Firmware Manual page 191

No. Name/Value
12.19 AI1 scaled at AI1
min
-32768.000...
32767.000
12.20 AI1 scaled at AI1
max
-32768.000...
32767.000
12.21 AI2 actual value
0.000...22.000 mA
12.22 AI2 scaled value
-32768.000...
32767.000
12.23 AI2 forced value
0.000...22.000 mA
12.25 AI2 unit selection
V
Description
Defines the real internal value that corresponds to the
minimum analog input AI1 value defined by parameter
AI1 min. (Changing the polarity settings of
can effectively invert the analog input.)
AI
scaled
12.20
12.17
Real value corresponding to minimum AI1 value.
Defines the real internal value that corresponds to the
maximum analog input AI1 value defined by parameter
AI1 max. See the drawing at parameter
AI1 min.
Real value corresponding to maximum AI1 value.
Displays the value of analog input AI2 in mA or V (depending
on whether the input is set to current or voltage by a hardware
setting).
This parameter is read-only.
Value of analog input AI2.
Displays the value of analog input AI2 after scaling. See
parameters 12.29 AI2 scaled at AI2 min
percent value.
This parameter is read-only.
Scaled value of analog input AI2.
Forced value that can be used instead of the true reading of
the input. See parameter
Forced value of analog input AI2.
Selects the unit for readings and settings related to analog
input AI2.
Note: In firmware ASCL2 and ASCL4), this setting must
match the corresponding hardware setting on the drive
control unit. See chapter Electrical installation, section
Switches in the Hardware manual of the drive and the default
control connections for the macro in use in chapter
macros (page 101). Control board reboot (either by cycling
the power or through parameter
required to validate any changes in the hardware settings.
Volts.
12.19 and
(12.12)
12.18
12.19
12.19 AI1 scaled at
and 12.101 AI1
12.02 AI force selection.
96.08 Control board
Parameters 191
Def/FbEq16
0.000
12.17
12.20
AI (12.11)
in
1 = 1
50.000
12.18
1 = 1
-
1000 = 1 unit
0.000
1 = 1
0.000
1000 = 1 unit
mA
Control
boot) is
2