ABB ACS560 Firmware Manual page 24

24 Start-up, control with I/O and ID run
Start, stop, and reference values
If you do not wish to use a macro, navigate to Main menu
 Parameter groups 20, 21, and
and reference.
Notes:
• Changing the start, stop, and reference settings, changes the I/O signals used in the
drive. You can see the currently used I/O signals in the
• Make sure that the used I/O connection matches with the actual I/O wiring. See
macros on page 101.
Ramp settings
Navigate to Main menu
change the parameters according to your need. For example, acceleration time,
deceleration time, emergency stop time etc.
After making the changes, press
view without making changes.
Limit settings
Navigate to Main menu
change the parameters according to your need. For example, minimum speed, maximum
speed, maximum current, etc.
After making the changes, press
view without making changes.
After the additional changes, make sure that the used I/O connection matches with the
actual I/O wiring. See
To see the currently used I/O signals, navigate to Main menu
status .
Use and to check the values.
After the additional adjustments and I/O connection
validation, navigate to Main menu
 Diagnostics
functioning correctly.
Diagnostics menu displays the active faults
history , active warnings
23 and manually define the settings for start, stop
 Complete parameter list
OK to accept or press
 Complete parameter list
OK to accept or press
3 – I/O menu
Control macros on page 101.
4 – Diagnostics menu
and make sure that the setup is
, and I/O status
 Complete parameter list
menu.
 Parameter group
(Back) to the previous
 Parameter group
(Back) to the previous
I/O menu
0 DI1
0 DI2
0 DI3
0
0
, fault
.
Control
23 and
30 and
I/O