ABB ACS560 Firmware Manual page 324

324 Parameters
No. Name/Value
Speed ref safe
49.06 Refresh settings
Done
Configure
49.19 Basic panel home
view 1
Auto
Motor speed used
Output frequency
Motor current
Motor current% of
motor nominal
Motor torque
DC voltage
Output power
Speed ref ramp in
Speed ref ramp out
Freq ref used
Process PID out
Temp sensor 1
excitation
Temp sensor 2
excitation
Abs motor speed
used
Abs motor speed%
Abs output
frequency
Abs motor torque
Abs output power
Abs motor shaft
power
AO1 data storage
Description
Drive generates an A7EE Panel loss
speed to the speed defined by parameter
safe (or 28.41 Frequency ref safe
is being used).
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
Applies the settings of parameters 49.01...49.05.
Note: Refreshing may cause a communication break, so
reconnecting the drive may be required.
Refresh done or not requested.
Refresh parameters 49.01...49.05. The value reverts
automatically to Done.
Selects the parameters that is shown in Home view 1 of the
Basic panel (ACS-BP-S) when the active external control
location is EXT1.
Home view 1 is toggled automatically between Home view 4
(parameter 49.01) according to the active external control
location EXT1 or EXT2, respectively
01.06 Output frequency
otherwise 01.01 Motor speed used
01.01 Motor speed used
01.06 Output frequency
01.07 Motor current
01.08 Motor current % of motor nom
01.10 Motor torque
01.11 DC voltage
01.14 Output power
23.01 Speed ref ramp input
23.02 Speed ref ramp output
28.02 Frequency ref ramp output
40.01 Process PID output actual
The output is used to feed an excitation current to the
temperature sensor 1, see parameter
source. See also section
The output is used to feed an excitation current to the
temperature sensor 2, see parameter
source. See also section
01.61 Abs motor speed used
01.62 Abs motor speed %
01.63 Abs output frequency
01.64 Abs motor torque
01.65 Abs output power
01.68 Abs motor shaft power
13.91 AO1 data storage.
warning and sets the
22.41 Speed ref
when frequency reference
(page 165) in scalar control mode,
used (page 165).
35.11 Temperature 1
Motor thermal protection
35.21 Temperature 2
Motor thermal protection
Def/FbEq16
3
Done
0
1
Auto
0
1
3
4
5
6
7
8
10
11
14
16
20
(page 82).
21
(page 82).
26
27
28
30
31
32
37