Install Blade In Housing - Fujitsu 1FINITY L100 User Manual

Equipment Installation

Install Blade in Housing

4.10

Install Blade in Housing

Prerequisites:
■ The 1FINITY Housing must be installed.
■ Verify power terminal adapter (AC00-SD11) is not installed on the rear of the blade.
■ The slot in the 1FINITY Housing where the blade is installed has power.
■ Screwdriver set (including straight-slot and Phillips head)
Danger: The blade is heavy and should be handled carefully. Do not use the fiber management arms to lift
and install the blade. Doing so may damage the blade, causing the blade to fall and personal injury. When
lifting or installing, position two hands in the center of the blade to avoid dropping the blade.
Step 1
Insert the blade into the appropriate slot of the 1FINITY Housing and slide it back until it locks in place.
Note: Fujitsu recommends installing the blade without the PIUs installed.
Attention: When lifting or installing, position two hands in the center of the blade to avoid dropping
the blade.
·
Release 19.1.1 Issue 1.1, May 2021
136
Fujitsu and Fujitsu Customer Use Only