Console Log - Fujitsu 1FINITY L100 User Manual

166
Initial System Turn Up
CONSOLE Port (Serial Port)
5.4.2
CONSOLE Log On
Prerequisites:
■ Release 19.1.1 software or later is required to use the CONSOLE port.
■ RJ-45 roll over cable is attached to the CONSOLE port.
■ The user must use the CLI for management.
■ The user must be logged on as fujitsu/1finity or must have Level-4 or Level-5 privileges assigned to perform
this procedure.
Note: The CONSOLE port should only be used for debugging or recovery purposes.
Note: For remote access, connect the CONSOLE port to a terminal server.
Step 1
Connect to the blade using an RJ-45 roll over cable to the CONSOLE port of the blade.
Step 2
Log on as user fujitsu on the command line.
Note: The default username, fujitsu, is used for initial turn-up. After initial turn-up, a user must use an assigned
username.
Step 3
At the password prompt, type 1finity.
Note: The default password, 1finity, is used for initial turn-up. After initial turn-up, a user must use a self-set
password.
Step 4
Start a CLI session by entering cli.
· Fujitsu and Fujitsu Customer Use Only
Release 19.1.1 Issue 1.1, May 2021